Applying cosmetic corrections
You can quickly apply the following cosmetic corrections to the subjects in your photos:
• blemish removal — by using the Blemish Fixer mode of the Makeover tool
• teeth whitening — by using the Toothbrush mode of the Makeover tool
• suntanning — by using the Suntan mode of the Makeover tool
• wrinkle removal — by using the Scratch Remover tool
- You can quickly remove blemishes, whiten teeth, apply suntanning, and remove wrinkles.
To remove facial blemishes
1 On the Tools toolbar, choose the Makeover tool
2 On the Tool Options palette, choose the Blemish Fixer fji mode. The pointer changes to concentric circles.
3 On the Tool Options palette, adjust the Size control to the smallest size that allows the inner circle to enclose the blemish.
The outer circle is used for the material that will cover the blemish.
4 On the Tool Options palette, adjust the Strength control.
Values range from 1 to 100. Higher values apply more of the source material (enclosed in the outer circle) to the blemish area (enclosed in the inner circle).
5 Point and click directly over the blemish.
6 ' You can zoom in on the photo, if necessary, for better control of the Makeover tool.
To whiten teeth
1 On the Tools toolbar, choose the Makeover tool
2 On the Tool Options palette, choose the Toothbrush mode.
3 Point and click directly over the teeth.
If the teeth are separated or partially obscured, you may need to apply this tool to each tooth individually.
The Toothbrush mode of the Makeover tool works only on color photos.
& ^ You can zoom in on the photo, if necessary, for better control of the Makeover tool.
To apply a suntan
1 On the Tools toolbar, choose the Makeover tool
2 On the Tool Options palette, choose the Suntan mode.
3 Type or set a value in the Size control.
4 Carefully drag over the skin you want to tan.
To remove facial wrinkles
1 On the Tools toolbar, choose the Scratch Remover tool 0.
2 On the Tool Options palette, choose either the square edge 1=1 or the beveled edge o selection box.
3 Type or set a value in the Width control so that the wrinkle you're removing fits inside the inner portion of the rectangle you drag.
4 Place the cursor just outside the wrinkle, and then carefully drag over the wrinkle so that it is enclosed in the inner rectangle.
The wrinkle is covered by the surrounding skin texture.
& ' If you need to start over, you can undo what you ve dragged out, adjust the Width control, and drag again.
For wrinkle lines that are not straight, correct just one portion at a time.
Post a comment